[LON-CAPA-users] Students with custom parameter settings don't show in overview mode

Lars Jensen lon-capa-users@mail.lon-capa.org
Fri, 13 May 2011 01:03:13 -0700

Hi Mark,

On Wed, May 11, 2011 at 5:46 AM, Mark Lucas <lucasm@ohio.edu> wrote:
> Lars,
> Are you talking about the Set/Modify Overview (the one in with
> table mode and helper) or the Modify Overview (which should list
> all parameters that exist in the course).
> I've been able to see all the parameters for students in the "Modify"
> (not set/modify) version in 2.10 and I don't remember any problems in
> 2.9.

Thanks! I found them. Existing Parameter are listed in two different
places, and I missed one of them.


> Have you tried logging onto a different server to see what happens?
> Mark
> On May 11, 2011, at 1:28 AM, Lars Jensen wrote:
> Hi Everyone,
> Is it no longer possible to see individual students' parameter
> settings in overview mode. Using table mode, I changed some parameters
> for an individual student, but when I look in overview mode the
> student's settings don't show, only the section shows. Before version
> 2.9 any student with individualized parameter settings would show up
> in overview mode....this was very handy. What happened?
> Lars.
> _______________________________________________
> LON-CAPA-users mailing list
> LON-CAPA-users@mail.lon-capa.org
> http://mail.lon-capa.org/mailman/listinfo/lon-capa-users
> --
> Mark Lucas  email: lucasm@ohiou.edu
> 252D Clippinger Lab phone: (740)597-2984
> Department of Physics and Astronomy fax: (740)593-0433
> Ohio University
> Athens, OH 45701